Customer Reviews

5 out of 5
Write a Review
  • All Reviews (5)
  • Image (1)
  • Video (0)
  • All Star
    • All Star(5)
    • 5 Star(5)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
  • 29/09/2019

    It needs cooling or heatsink over 2A

    Comments
  • 30/06/2020

    This is the tougher cousin to the 1.3A (1.2MHz switching) version. Whilst the voltage adjustment pot seems to be of reasonable quality compared to the crap ones used on the "Geekcreit® Mini DC-DC Converter Step Down Module" (and its clones), unless you need an in between oddball voltage setting (6 or 7.5 volts for example) and have the patience to finesse it onto the required voltage setting - it's very touchy, you'd be better off cutting the trace (at its necked point) which bridges the Adj option solder blob link (you can still blob this link if you need to restore the Adj option) and solder blob the required standard voltage option link. Cutting the Adj option bridging link so you can choose a fixed voltage setting is a safer option - no risk of the trimpot falling apart or going open circuit to over-volt whatever 3.3 or 5 volt rail you're powering with just one volt short of whatever the input supply voltage happens to be (12 to 24 volts perhaps?). Testing the fixed 5v option gave me a tad less than 5 volt (4.95 something volts). Ideally, I wanted a voltage between 5.2 and 5.3 volts so tried blobbing both the 9 and 12 volt option bridges instead which gave me 5.31 volts - right on the money as far as I was concerned. :-) These "3A" versions run a lot cooler compared to the "1.3A" version when testing with a one amp load so should be more robust than their 'weaker cousins' whose overheating/overloading protection seems somewhat lacking since I manage to make a 1.3A one start emitting its magic smoke due to a 5v CMOS RRO dual opamp shorting out the 5v supply rail in a Mark II version of a DIY GPSDO I had been testing (most likely a design error on my part, now since remedied). The specs mention 20mV of ripple noise which will be the RMS value. The peak to peak value will be approximately three times this value, circa 60mV p2p which is quite good and easily reduced to less than 10mV p2p with additional filtering if needed. JBG

    Comments
  • 23/05/2021

    Perfect for my needs! Fast shipping.. Might order more..

    Comments
  • 16/01/2020

    handy little modules that can provide a fixed 3 5 9 or 12 volts by cutting a track on the pcb & soldering a couple of pads to select the right voltage or can be adjusted using the small trimmer on the board.

    Comments
  • 12/01/2020

    All ok

    Comments
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$5.99
    • US$8.99
    • US$6.99
    • US$26.99
    • US$13.99
    • US$5.99
    • US$9.99
    • US$7.99
    • US$7.99
    • US$11.87
    • US$6.99
    • US$7.99
    • US$8.99
    • US$7.99
    • US$2.15
    • US$3.49
    • US$6.99
    • US$11.99