A part of the review has been auto-translated.
Highly recommended! Its even smaller than you think. Flashed via Wifi, no problems. Uses the same firmware as what you will load for the EP24S. Flash with DIY_2400_RX_ESP8285_SX1280. Remember to run TX/RX crossed to RX/TX on your FC. Betaflight settings is only; Soldered to uart port switched to serial and selecting CRSF under transmitter in the Configuration tab. Build quality is very good! Weight listed in product details is spot on. Does not come with heat shrink. No problems binding with HappyModel ES24TX 2.4GHz v2.0. Default wifi 10.0.0.1 password: expresslrs
All good. Works perfectly. Tiny. Comes with wires but no heat shrink. The Happy Model Rx comes with heat shrink, stickers and no wires. What I've learned regards ELRS..... IF YOU HAVE AN F411 FLIGHT CONTROLLER you will need to swap UARTS around with VTXs Rx and Tx pads ( Video and Smart audio) to get it to work. Thanks Albert Kim of YouTube for that brilliant bit of information. Use DIY 2.4 device and target - previous reviewer lists it.
Now I bought 2 other elrs rx with build on antenna just too test them out, and see which one out of three will come out on top! JHEMCU well done on a super small rx. The real teat will be the setting up process and how well it operates at extreme distances. Stay tuned!
Fits great in my little drone
Fast delivery. Great product!
very well the receiver is tiny.
the Jhemcu 900rx has no flashing software .. but you can use the betafpv flashing for this...good product smaller than I expected
this is the second or third I have bought - it just works as it should
Great product and it performs amazingly well! Good range on my micro quads.
It is a super tiny rx. I use it in my micros (2"-3") and I feel the difference. I did not test the range yet, but it is not important for me though. The binding and firmware flashing is super easy. I recommend!