All Messages

GreenscOOps the standard firmware only allow you to use 6 channels. you need to buy the firmware update cable and download the custom firmware from github.

2022-07-25 07:39:07 Helpful (0)
Submit
Answers (6)

pfeerick I've not used the Flysky i6 transmitter personally, but it is telemetry capably, and has the sensors list and choose sensors options under "system - rx setup". However I do have both this receiver and the smaller 6CH version, and to use sensors to monitor things like flight battery, altitude, RPM you use the SENS iBus port. And for basic RSSI, receiver voltage, etc, you don't need to connect anything, that is sent anyway.

2022-07-16 11:23:22 Helpful (0)
Submit
Answers (1)

qurlson Matek have receiver, or another china receivers and use 5.8 vtx for repeat signal in goggle

2022-06-04 12:19:26 Helpful (1)
Submit
Answers (1)

GreenscOOps there is no configuring the gps but yes on screen display can be setup to show distance to the home point which only works if you have a gps on your craft.

2022-03-22 02:08:37 Helpful (0)
Submit
Answers (2)

Q: Can i Connect the receiver with 7,4volt 800mah lipo and bec?

Asked by alextattoo on 2020-01-06 11:42:08

GreenscOOps as long as the BEC outputs 5v. You don't want to plug a 2s lipo directly into the receiver.

2022-03-22 02:05:31 Helpful (0)
Submit
Answers (2)

Q: Does this works with the FC Racestar Star F4s 30a

Asked by armandomonroyph on 2019-10-29 06:40:19

GreenscOOps it will work with any flight controller that's has a spare UART.

2022-03-22 01:43:25 Helpful (0)
Submit
Answers (2)

Q: does this ESC work with any brushless motor

Asked by Utsav Atul on 2018-02-07 08:01:42

GreenscOOps any brushless motor that has a maximum current draw of less than 30 amps

2022-03-09 03:51:25 Helpful (0)
Submit
Answers (2)

Q: Which side on top of this GPS unit, please? Thanks in advance!

Asked by SilverSurfer on 2018-06-29 09:22:49

GreenscOOps antenna side up. the side with the little dot in the middle.

2022-03-09 03:49:41 Helpful (0)
Submit
Answers (3)

GreenscOOps it can't run off of USB power you need to plug in the battery also

2022-03-02 06:08:35 Helpful (0)
Submit
Answers (6)

Q: how much Ampere esc cao use

Asked by BG571710105 on 2022-02-15 11:16:02

GreenscOOps well it says the max current the motor will pull is 11.5 amps so you'll need a ESC that can handle at least 12 amps but a little higher might be better just in case so a 12-20 Amp ESC will do. I use a 30A ESC because it was what I could find cheap.

2022-02-16 06:18:03 Helpful (1)
Submit
Answers (2)