All Messages

Q: What sizes in this kit?

Asked by Hanvp on 2020-11-20 10:53:19

Astacology Dear customer, Thank you for your support and understanding. If you have any other question please contact our customer service : cservice@banggood.com freely. we need some time to ask the supplier,you can contact the live chat. They would help you. Best regards

2020-12-06 12:59:30 Helpful (0)
Submit
Answers (1)
Hanvp 2018-05-30 17:40:32
1
Recommendations
Comments (0)
Hanvp 2019-07-10 06:15:31
A very detailed kit. Wonderful to have an all metal drive train (except transfer case, which is plastic). I began assembly of the axles and found some majour problems. The input gear is far too tight against differential gear. The problem was solved by making a gasket (coffee cup paper). Not easy but follow a simple routine and all will be well. Kit comes with 'red' threadlock, do not use this. Use 'blue' lthreadlock. Red lthreadlock will make it extremely difficult to remove parts. If you are concerned about using automotive blue lthreadlock use the Tamiya 'liquid threadlock'. The four screws holding the differential together have off-round heads. They will require some force to seat properly. In the process some red paint will be damaged. The differential covers do not fit the location holes. Drill these holes with 2mm drill and you may still require to remove the paint from the pins. Also the four screw holes are best drilled out with 2.5mm drill (do not drill the input side (black). The 'brake drums' do not fit. Carefully file the axle ends until drums fit snugly. To make the differential gasket 1. Assemble the axle cases together. (elastics wrapped around the axle housing will do) 2. a Place small square of coffee cup paper (do not worry about the overall fit yet) 3. Drill a 2.5mm hole through the paper. Place it on axle and use screw to hold the paper against the axle. 4. Drill the second 2.5mm hole and insert screw (placing screws in hole will assure accurate location of holes) 5. Repeat for other two screw holes. 6. Now drill holes for location pins with 2mm drill. 7 Mark out the inner opening ,with sharp object (pin or exacto knife) Leave the four screws in place. 8. Remove the four screws and paper. 9. With exacto knife cutout the opening 10. Place paper on the differential cover, located with the four pins and cut gasket to shape of differential cover. You now have a sturdy gasket the fits perfectly. If concerned about a 'white' gasket, use a magic marker
0
Recommendations
Comments (0)

Hanvp Use scanner and photo program to enlarge each page to 8.5" x 11" paper. Instructions now very legible.

2018-10-27 03:40:37 Helpful (0)
Submit
Answers (4)

Hanvp A majour part of this "kit" is pre-assembled. The axles and gear box are pre-assembled

2018-09-11 10:16:52 Helpful (0)
Submit
Answers (2)

Funtom It should be assembled by yourself,it is a features you canot find in the RTR car

2018-08-15 08:58:45 Helpful (0)
Submit
Answers (1)