Krm_27
Q: is this fc support DJI osd?
Asked by Bonczas on 2021-01-15 07:02:21
BG135644255 Yes,there is a socket compatible with the DJI Air unit that you can directly connect and activate.
2024-03-15 02:01:46 Helpful (0)
BG135644255 Youneed to connect it to GND, 5V and TX1 pins on the flight board. These pins must correspond to the GND, 5V and RX (IBUS) pins in the B-VCC section on the receiver. Enable the "ports-uart1-serial rx" option in Betaflight. Then "Serial via Uart" and IBUS will be selected in the receiver section. This much.
2024-03-15 01:58:01 Helpful (0)Q: Can I install a barometer and will it Altitude Hold?
Asked by Dan3315 on 2020-06-24 11:20:38
BG135644255 Yes,altitude can be maintained by connecting a barometer and compass to the SDA-SCL pins with a quality GPS, but it is not possible to make this flight card like DJI. It requires quality hardware and minimal vibration. If you want to hold the position you should use inav but I know there is no gyroscope support (for INAV) for this FC. Still you should try.
2024-03-15 01:47:33 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
