kiriba
Q: Any tips how to connect external start-stop button? With wiring diagram.
Asked by kiriba on 2019-03-22 03:52:37
routercnc I did a video on this recently. Search 'routercnc' on YouTube and look for the series on 'Upgrading a drill press'. I went into detail on the external controls and showed how it is done.
2020-02-14 03:25:38 Helpful (1)
Q: does this item hold a 1/2" router cutter
Asked by Graham Pollitt on 2018-03-15 02:21:43
kiriba You can use 1/2" bits with 13mm metric collet.
2019-01-17 05:49:11 Helpful (0)
kiriba Nut ring is excentric to hold the collet. You need to check internal cone surface to measure actual off-center.
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
