All Messages

CodfishCatfish The laser has a built in safety feature that prevents it from being on. You must use the software to make the master turn on to calibrate and focus the laser. Unless your are ready to cut the laser will never be on. Also the laser uses PWM technology so you must make sure the laser is pulsed with the lowest pulse at first while you focus.

2020-10-12 12:03:15 Helpful (0)
Submit
Answers (1)

CodfishCatfish Do you offer one that will......seems like a perfectly OK question. Why the hostility?

2020-09-11 10:18:03 Helpful (0)
Submit
Answers (4)

CodfishCatfish It uses a Micro USB connector and is programmed with the Arduino IDE. You may have to search the Boards manager for the correct driver. If just using the ESP8266 part then that will need the correct driver. If using the Mega2560 part then that is already included in the latest Arduino IDE. DIP switches allow you to select which programming area.

2020-08-04 03:58:20 Helpful (0)
Submit
Answers (2)

Q: What filament can it use

Asked by BG113354171 on 2020-06-08 01:48:02

CodfishCatfish I have successfully used PLA, ABS and TPU but you will have to adjust your settings for each. Some filaments require different Nozzle and Bed temperatures.

2020-06-08 02:17:23 Helpful (0)
Submit
Answers (1)

Q: it is suitable for balance charger imax b6??

Asked by jaydeep505 on 2018-07-01 10:45:53

CodfishCatfish Yes this should fit bit only the plug side.

2020-05-29 09:29:01 Helpful (0)
Submit
Answers (1)

Q: ok for tx and rx cell booster ?

Asked by BG573717452 on 2020-05-28 08:29:43

CodfishCatfish No, this is a LNA or low noise amplifier. It can only receive RX and cannot TX.

2020-05-29 09:27:46 Helpful (0)
Submit
Answers (1)

CodfishCatfish The extruded has an ABS case as seen in the picture with a Silicon cover inside that. There are two fans attached to the extruded head. One is an extruded cooling fan and the other a snail fan for cooling the print job.

2020-05-29 09:25:58 Helpful (0)
Submit
Answers (1)

Q: Does it have an I2C bus?

Asked by Andy on 2020-02-29 02:05:38

CodfishCatfish Yes it does on Pin 20 and Pin 21.

2020-03-05 12:27:42 Helpful (0)
Submit
Answers (1)

CodfishCatfish If you see the description it indicates Input and output on the same pins. You charge with the same pins as your output. Just as if you were charging a 12v SLA, the battery board takes care of balancing and battery overvolt and short as well as low voltage cutoff. So yes use the same output pins to charge as they are output and input. However, depending on the model you will need more voltage that 12v for 11.1v as 3x18650 = 4.2vdc fully charged so more than 12.6v.

2020-02-02 04:00:14 Helpful (2)
Submit
Answers (1)

Q: will this work with Google assistant and Alexa?

Asked by Pushpinder Pal Singh on 2018-07-18 11:00:32

CodfishCatfish No, this device only works with Mijia.

2020-01-10 11:36:36 Helpful (0)
Submit
Answers (1)