All Messages

Q: Para que serve essa peça?

Asked by fabricio on 2018-08-14 01:27:56

HugoBiermann You also have to buy the spur, motor mount and pinions separately. If you want to shift between high and low gear, also the shift servo.

2021-10-26 12:32:24 Helpful (0)
Answers (2)

Q: i know it will be underpowered but will it be able to work on +/- 40v supply?

Asked by on 2019-01-03 02:56:21

HugoBiermann It might, power will be way down though. You might be better off with a different module.

2021-10-18 06:51:15 Helpful (0)
Answers (2)

HugoBiermann 3duim. Werk heel goed in die spot waar ek een install het.

HugoBiermann 11/12/2020
Comments (2)

Q: I have ZMT-10 by ZD racing. This part is fit for ZMT-10?

Asked by Taka_02 on 2019-07-31 07:03:58

HugoBiermann Its mod06 pitch. If the other car is the same you should be fine. Mod06 should work fine on 48p, essentially the same thing.

2021-10-07 12:23:21 Helpful (0)
Answers (1)

Q: you use these for 1:12 rc crawlers?

Asked by BG501622953 on 2020-10-27 08:02:02

HugoBiermann They need modification to work ok on a crawler. Springs are a bit too stiff.

2021-10-07 12:17:48 Helpful (0)
Answers (4)

Q: when is the blue one back in stock again?

Asked by jeroenmpdj on 2020-08-15 04:46:45

HugoBiermann They’re almost out of stock again! Buy Now!

2021-09-29 06:54:46 Helpful (0)
Answers (5)

Q: will both the pin and hex work in the 144001 version?

Asked by BG124622175 on 2021-09-14 05:37:22

HugoBiermann You can always just use your stock pin and just the new adaptor

2021-09-18 01:49:40 Helpful (0)
Answers (1)

HugoBiermann They are 100mm long end for m3 hardware. Stiff enough for general 110 basher or trail rigs. You should decide.

2021-09-11 12:56:23 Helpful (0)
Answers (2)

Q: Is it for XT60 batery ?

Asked by BG233253843 on 2020-01-29 02:29:31

HugoBiermann Make an adaptor or solder one in the place of the deans

2021-09-09 01:45:25 Helpful (0)
Answers (17)