lfisk
lfisk The black handle is press fitted to the shaft. The shaft on mine has a taper that mates with the chuck. There are two little roller bearings that spin freely between the two. The taper fit chuck is a bad design for a hand tool. Comes loose much too easily. Another commenter mention it was 3/8 x 24 threaded but the one they sent me isn't...
2017-12-31 12:19:36 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
lfisk The main shaft on mine received December 2017 is 10mm/0.390 inches. Across the two bearings is 16mm/.630 inches. They don't all seem to be made the same. Mine has a taper fit, press on chuck. Other reviews say it is threaded...
2018-02-01 07:57:31 Helpful (1)