KINGKONG/LDARC Flight Controller Fix Mount for 30.5X30.5MM CC3D NAZE32 for RC Drone FPV Racing
A part of the review has been auto-translated.
good for whoop to stack fc modes and it’s hard plastic, so no potential shorting issues/mistakes. It sits a little too high, but I guess one could always file it down to the preferred height
Use it in my S800 wing. Drilled 4 holes in the foam and stuck in the mount. Glued it too. Than I cut a M3 thread in every corner of the mount and screwed Anti-Vibration Fixed Screws in them.
Good product. Makes sure that the flught controller is not touching the carbon surfaces of the quadcopter and also ensured it is level. I put one in every build. Worth the buy.
nice quality base for any FC board
Perfectly packed, Arrived quick and with no damage.
Nice product, very useful to mount your 30x30 video transmission to 20x20 mounting hole
Very useful with all these different FC standards, with these you could easily mount a 15x15, 16x16, 20x20, 25x25 FC to a standard 30.5x 30.5 frame.
Super nice small piece of hardware. Bought it first time just in case. This is my third one :) Super clean way to combine 30x30 and 20x20 components. And you can sand down the legs to keep even lower profile if needed.
maybe i will use this for 30x30 to 20x20 adapter
good product