Customer Reviews

4.89 out of 5
See all 174 reviews
Write a Review
  • All Reviews (174)
  • Image (8)
  • Video (2)
  • All Star
    • All Star(174)
    • 5 Star(161)
    • 4 Star(8)
    • 3 Star(4)
    • 2 Star(0)
    • 1 Star(1)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
Show Original

A part of the review has been auto-translated.

  • 30/04/2016

    excellent receiver , once flashed with new firmware Flashing details:- CH5-MOSI CH6-MISO CH7-SCK VCC GND RESET ( attach before plugging in usbasp) Programable fail-safe (PFS) and binding of RX-F802:- 1) Press bind button on RX and power it up , release button . Led will stay on 2) Turn on Taranis :- press menu button and then page button . Scroll down and set mode=d8 and channel range =Ch1-8. Then enter bind . 3) RX led will go off 4) Arrange sticks for your preferred fail safe 5) Press ENT button on Taranis to exit bind 6) RX will flash 7) Remove power to receiver and re- connect , it should come on with a solid led 8) Your done , receiver bound and fail-safe set PPM out:- connect channels 1+3 , PPM out will be on channel 4 Sbus out:- Connect channels 5+7 . Sbus is on tx pad under rx cover next to Ariel RSSI ( signal strength) :- RSSI is output on Channel 5 when in SBUS or PPM mode for most firmwares. It can be put on channel 9 when the cleanflight software is loaded For MWOSD the min rssi should be set to 33 and the max to 100

    Comments (1)
    Show Original
  • 19/08/2015

    Nice little rx, lightweight, small, e.g. half height of a R615X. Hence this one will fit even on small frame. For the A1&A2 ports, it comes with two bread board cables. The antenna is a dipole antenna, but I am wondering why most Chinese builders of that stuff stay below 1/4 wave for the length on the active part.. After I have done the mod on the 7e for this rx, I will report how the telemetry works.

    Comments (11)
    Show Original
  • 15/10/2015

    Athough only single antenna it is pa/LNA and dipole antenna , new fw is available search diy frsky RX , a guy called Midelic has written the code for this, also his code now Inc!uded all CH failsafe and s.bus and fast reconnect if signal lost. More to come may include more telemetry like altimeter.

    Comments (1)
    Show Original
  • 21/07/2016

    Ideal receiver to use on planes, helis, multicopters or flying wings. I am using it on a FPV flying wing and works great. On my Taranis I have the telemetry for RSSI and Battery voltage, just what I looking for. The real advantage it's that don't need any voltage divider, just plug from the balance plug of my 3S lipo battery to the receiver A1 port and get the value. Just perfect.

    Show Original
  • 15/03/2016

    rock solid performance updating guide here:

    Show Original
  • 27/11/2020

    Satisfied, binded to 1.x, full 7 channels to use 1 binding, In Taranise plus after plugging the cable with service battery cable transmits the status of the battery max 3s to the receiver in section - A1. Best price on 7 channel - satisfaction. Google trans: Satisfied, complete to 1.x, full 7 months for use 1 month, in Taranis plus after the service of the operator used it again with the highest status max 3s to the operator in connection - A1. The best price for channel 7 - destination.

    Comments (2)
    Show Original
  • 10/09/2015

    Telemetry and control confirmed, not had the weather for flying yet but this is a great cheap receiver. No reason not to trust it.

    Show Original
  • 08/01/2016

    not sure about the range with single non diversity antenna but works ok for ~500m - using it with a trainer with a lot of functions(lights, telemetry etc). To update firmware you need an avt usbasp programmer , remove the case and there is a RESET pad for programming.

    Show Original
  • 01/01/2016

    Projet maintenu par Midelic sur rcgroups : De nouvelles fonctionnalités sont ajoutées régulièrement. Récemment le Failsafe et le S-BUS.

    Comments (1)
    Show Original
  • 28/11/2016

    When I received the RX, I found out that it was only 7channels. Also, it has no bind button. Have to use strap for binding. A complaint has been raised with Banggood.

    Comments (1)
    Show Original

    Total 0 pages

    Go to page

    recommendation for you
    • US$16.99
    • US$20.99
    • US$182.99
    • US$4.99
    • US$38.99
    • US$57.99
    • US$64.99
    • US$9.99
    • US$9.99
    • US$7.99
    • US$81.99
    • US$11.99
    • US$25.99
    • US$8.99
    • US$99.99
    • US$25.99
    • US$223.99
    • US$49.99