Customer Reviews

4.96 out of 5
See all 350 reviews
Write a Review
  • All Reviews (350)
  • Image (35)
  • Video (2)
  • All Star
    • All Star(350)
    • 5 Star(337)
    • 4 Star(12)
    • 3 Star(1)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
Show Original

A part of the review has been auto-translated.

  • 01/02/2014

    A good timer that is easy to adjust. It has normally open and normally closed contacts. The third input next to the 12 v and ground terminals is the trigger contact. a momentary application of 12 v to the trigger starts the timer which continues even if the trigger switch is opened before the time cycle is finished. there is a red power led and a blue timer activated led. The maximum time cycle is 999 seconds.

    Show Original
  • 28/06/2022

    Ok. product received but a little long. not know how to use, connect the wire to use

    Show Original
  • 20/06/2020

    Received very fast even being for Brazil, haven't tested yet, it's always good shopping at Banggood, I indicate.

    Show Original
  • 03/05/2019

    ήρθε γρήγορα ,τώρα όταν φτιάξω την Πόντα πιστεύω να μου κάνει .

    Show Original
  • 06/04/2019

    good quality

    Show Original
  • 16/01/2019

    top für das Geld und einfach einzustellen

    Show Original
  • dinitro

    Good part looks great.

    Show Original
  • 03/04/2018

    Bine lucrat si functioneaza perfect,recomand.

    Show Original
  • 24/03/2018

    It works fine! Perfect for DIY constructions!

    Show Original
  • 23/03/2016

    I use the timer on a boat where a pump has to run sometimes for 2 minutes. This time is too long to wait for, so it often happens thati fotget to swich it off, so the pump runs for hours, wich is bad for the pump. I connected it slightly different, the standby consumption is now zero! This works only if the item to be switched work on 12v, same as the power for this timer. First connect as indicated, and set the timing you need. Then connect the power supply for the timer (+12v) to the same connection as where you connect the load. Also connect the trigger to the same point. If you switch on the power (in my case the existing switch) and off after a second or so, the load (pump) wil be on for for the selected time! I am verry happy with this excellent and cheap item! I will try later to upload a picture of how to connect.

    Comments (1)
    Show Original

    Total 0 pages

    Go to page


    You might be interested in

    recommendation for you
    • US$5.99
    • US$12.99
    • US$5.69
    • US$25.00
    • US$11.99
    • US$1.99
    • US$8.99
    • US$366.99
    • US$1.99
    • US$4.99
    • US$4.69
    • US$1.00
    • US$2.99
    • US$1.99
    • US$7.99
    • US$0.99
    • US$11.99
    • US$19.99