1PC Metal Transfer Gear Case w/370 Motor for WPL B-16 B-24 B-36 C24 JJRC Q60 Q61 4WD 6WD RC Car
A part of the review has been auto-translated.
insane power and torque for the money.! and the motor is rebuildable. so many options for so many vehicles with one power plant. It's a must-have for any wpl or jjrc owner. and yes, that's a wpl c24
This is the second set of these axles I've purchased. They are going on my B1 WPL for a little mass and a lot of strength. They are going on with the metal earing spring set as well as the metal gear box 370 motor. I took the unscale looking wheels off my FY004a and put them on the Bi which I expect to now be a competent crawler. Nice materials and delivered to Canada in just two weeks. I'll keep on buying from these folks.
Looks like good quality. Hopefully it will last more than my stock motor on a WPL c24-1 which burned after a few runs. The gears are really good and for sure you loose in speed but you get a real crowler with lots of torque. Totally recommended for WPL c24 the result is a new car. You have to go through some mods like cutting a lot of plastic to fit the trunk part of the body but that's ok, no big deal. the weight also is good enough so you get a lower center of gravity. As a result you will have at least 5 degrees gain in climbing than the stock
Good solid construction, just take the time to make sure everything is tight. I like the appearance.
good quality metal gearbox, did find that one of the shafts needed to be grinded down to be able to fit the grub screw but easy fix. can be made to fit a fayee fy004 or eachine equivalent. easy mod but very much worth the work.
parts look and feel great. am excited to use them when my rig is fully built. Will certainly order again.
Arrived but they didnt seperate any if the screws or hardware or so be very careful when you pull it out of the bag!!!All the screws and hardware are stuck to the motor and very easy to lose pieces just F.Y.I..Other then that it all looks good and nice and heavy!!Seem like quality made pieces and parts etc...Definitely recommend for the great price!!!Also the heat sink you may have to close or bend a lil tighter by hand to your preference of fitment around motor or trans part!!!It's very loose but easily modifiable to work where you want it...Thank you again for another purchase Banggood!!
Axial puffs everywhere, special attention to the gearbox inside, in the ring between the motor and the direct gear with three gears (of very soft steel), there are very small gears without bearings, in the direct gear where all gears are the same, lubrication minimum, landing on the shaft of bearings play, as well as landing crankers, without suspension bearing on the long shaft (for version 6x6) on metal cardans will break the landing and then the bearings, vol. K. the shaft is too long. In general, 10-15 serious rides will work if opened and lubricants added. The approach seems to be right, but the marketers are screwing things up again. It's all about the gearbox, not those three straight gears on the motors you sent, and it doesn't smell like bearings, even though it's metal everywhere. Besides came not the one in the photo in the description, with the heads of the screws in the butt, and me with the exterior ones. The seller sent in 10-12 days arrived 28 days later in the Sverdlovsk region.
very sturdy of body and on the gears, but before installing you have to grease the gears (they are dry) of the box to avoid wear. it is just as shown, easy to assemble and quick to install -- I arrive very quickly
excellent product thanks super recommend to the seller