All Messages

Q: when will this be back in stock ?

Asked by keithp on 2019-04-06 04:29:05

Szczypior There are alternatives on the BG with similar AWG

2023-04-24 03:46:39 Helpful (0)
Answers (1)

Q: black and red wires on rear camera what is it for ?

Asked by sergzadoroz on 2017-11-29 07:05:57

Szczypior It's for powering it. There is separate connection of the circuit required in order to rear camera to work.

2023-04-24 03:44:49 Helpful (0)
Answers (1)

Q: does it come with the transmitter

Asked by BG403745454 on 2023-04-24 06:44:32

Szczypior This is reciever only. Transmitter has to be bought separately

2023-04-24 03:44:37 Helpful (0)
Answers (3)

Q: hey does it come with everything needed to run controller ect

Asked by rcmad94 on 2020-10-31 02:51:16

Szczypior This is a KIT version, so basically a plastic model without any electronics. mine came with a motor, but no ESC or receiver.

2020-11-01 12:43:26 Helpful (0)
Answers (1)

Q: Is this in stock? Do I need a special antenna for this?

Asked by Sarbjit Billing on 2020-06-03 06:50:49

Szczypior It comes with no antenna so you need to order them separately. It uses SMA connector. Of course it's 2,4GHz reciever.

2020-06-03 06:54:01 Helpful (0)
Answers (1)

Szczypior The communication in group is terrible. Bad comments are deleted, so Helikido is actually not right and delusional.

2020-05-21 12:11:12 Helpful (0)
Answers (16)

Q: FURYF4OSD (Legacy) or (Diatone)?

Asked by dariuszkazmierczak8 on 2020-05-16 02:04:16

Szczypior Diatone site states it's legacy.

2020-05-16 02:16:44 Helpful (0)
Answers (4)

Szczypior No, there is no such possibility. Device has no battery. Image quality isn't good enough for such application. You will be better with your smartphone. And I mean even the old one.

2020-05-07 07:38:14 Helpful (0)
Answers (1)

Q: Is the thread straight through?

Asked by Sarel MVenter on 2019-09-02 06:22:21

Szczypior In my case it was.

2020-04-04 02:39:00 Helpful (0)
Answers (1)

Szczypior Any kind of LEDs, but keep in mind that 5V regulator has limited amperage. If you are willing to use some high power LEDs then you just take signal pad from FC and power up LEDs from other source. Of course this FC is not dedicated to any kind of LEDs manufacturer.

2020-04-04 02:38:17 Helpful (0)
Answers (8)

Q: Will the Pin of Battery Fit with Nano Fpv Camera Pin??

Asked by adityash840 on 2018-06-15 07:19:08

Szczypior Very unlikely as this is PH2.0 and cameras use smaller plugs in most cases.

2020-03-27 05:00:38 Helpful (0)
Answers (1)