All Messages

boejoa54 The heater is somewhat sluggish in terms of regulation. If the heater is little ümspühlt comes the indicator LL or HH. This means the heater is well above or below the control range. Then the warning beeps. As soon as some time has passed, the slider rebalances and the beeping stops. Solution 1 Influence the heater more strongly. Solution 2 Solder the beeper from the circuit board. But be careful!!! Then you can only see if the heater works. The heater is somewhat sluggish in terms of regulation. If the heater is little washed around, the display shows LL or HH. That means the heating is clearly above or below the control range. Then the warning comes. As soon as some time has passed, the controller levels itself again and the beeping stops. Solution 1 Knock over the heater more. Solution 2 Solder the beeper from the circuit board. But beware!!! Then you can only see optically whether the heater works.

2020-06-14 06:15:22 (1)
Answers (1)