All Messages

pastorchrisdare The holes did not need to be retapped. I was putting it together wrong. This is precise and works well. I am very pleased with it. To control the width of the cut, there is a stop on each side. The stops are not screws. They are slides which are secured with set screws. Loosen the set screws, slide the stop to the proper position and secure them with the set screw. I measured each stop with a dial caliper to assure the cut was centered. This is well made and works well. Some instructions would make it perfect. Instead you have to guess your way through assembly and operation.

pastorchrisdare 26/04/2022
0
Comments (1)

pastorchrisdare Thehorizontal limits look like screws since the ends are knurled. They are not screws. They are slides. The slides are held in place with small set screws. Allan wrenches are included for these set screws.

Giboli 10/04/2022
0
Comments (2)