All Messages

sansjunk No, it only has signal and ground wires. You will need to use an additional BEC.

2023-01-06 11:19:53 Helpful (0)
Submit
Answers (2)

Q: Any reviews about this 3D printer?

Asked by sansjunk on 2019-12-11 08:54:48

thaleskoba It'sa nice model to start learning about 3D printing

2022-11-21 07:49:17 Helpful (0)
Submit
Answers (6)

sansjunk Yes, that's true. And they have stopped shipping to my country as well. Time to look elsewhere.

2022-10-12 10:41:45 Helpful (0)
Submit
Answers (2)

Q: Will this work with flysky recievers IBUS protocol

Asked by BG501838122 on 2022-08-26 09:31:15

sansjunk Unfortunately, Flysky will not work with this radio as it has only the CC2500 RF chip. Flysky needs A7105 RF chip.

2022-08-30 12:02:07 Helpful (1)
Submit
Answers (1)

sansjunk Yes, you can but the output power will be limited. Depends on the size of speakers you plan to use.

2021-11-18 11:39:04 Helpful (1)
Submit
Answers (3)

Q: Will this work on 32650 batteries ?

Asked by BG455119147 on 2021-11-01 12:13:11

sansjunk It all depends on how much instantaneous current the batteries can supply without the voltage sagging. I tried to use an old car battery (still functional but past its prime) and I couldn't get good welds. I finally bought a pair of 3S lipos (2200 mAh each) and put them in parallel (so 3S 2P) and was able to get good welds.

2021-11-02 10:26:11 Helpful (0)
Submit
Answers (5)

Q: If I get a parallel charging board, can I change a 1s battery?

Asked by BG236501218 on 2021-10-16 10:01:56

sansjunk Yes, you can. There will be a warning about it but it does allow. However it will not show the internal resistance.

2021-10-22 05:30:23 Helpful (0)
Submit
Answers (5)

Q: Does anyone know what the extra lead with JST connector is for?

Asked by sansjunk on 2021-09-11 10:31:53

ABDDWDSHA refer to the description please

2021-09-22 04:28:11 Helpful (0)
Submit
Answers (1)