troh
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

troh 28/05/2020
Good quality car charger for my phone. The build quality feels much better than no-brand chargers and charge current is as expected.
Oneplus Dash Fast Car Charger Quick Charging Car Charger for One Plus Oneplus 3 3T 5 5T 6
US$21.99 US$26.99
0
Recommendations
Comments (0)
troh 18/07/2019
This is my antenna choice for 2019 season. Goggle setup is one antenna directly to receiver and other via 90deg angle. Drone setup just 45deg and little bit above pod. Works fine in FPV race tracks. Maybe not the best for long range, but perfect for racing.
2pcs Foxeer 5.8G Lollipop 3 2.5DBi Stubby Omni FPV Antenna LHCP/RHCP for RC Drone Airplane
US$17.99 US$27.59
0
Recommendations
Comments (0)
troh 18/07/2019
Basic MMCX to SMA pigtail. Note that spec states length of 120mm and thus in most of VTX location you need to shorten the cable. SMA is easy to remove, cut and solder back. MMCX is more difficult to re-solder.
1PC RJXHOBBY RF RG316 Pigtail SMA Female Antenna Connector to MMCX Male Coaxial Adapter Right Angle
US$7.99 US$9.59
1
Recommendations
Comments (0)
Original Xiaomi 2 in 1 bluetooth Mini Extendable Folding Tripod Selfie Stick For Mobile Phone
US$24.99 US$29.99

Q: compatible with samsung s9+?

Asked by nuno18_ on 2019-07-30 04:46:24

troh Workswith all Bluetooth enabled devices which width is within reach. Samsung s9 seems to be supported size.

2019-07-30 07:25:14 Helpful (0)
Submit
Answers (7)
XIAOMI Mijia 24 in 1 Multi-purpose Precision Screwdriver Set Aluminium S2 Steel Repair Tools
US$32.99 US$42.99

Q: Is it hard enough to get the job done and last long?

Asked by np481 on 2019-07-30 02:25:18

troh Bitsare made out from quality steel. Grips well enough to get job done.

2019-07-30 07:23:54 Helpful (0)
Submit
Answers (8)
troh 30/08/2018
This is handy piece to mount a battery with XT60 connector to FPV goggles. Specially handy for those goggles that can accept 4S LiPo so that you can you quad batteries if goggle battery dies during race day. The black part is 3D printed and doesn't fit perfectly. Thus the quality appearance is not the best possible. However, it does the job.
RJXHOBBY Fatshark ImmersionRC Goggles Battery Adapter for Lipo XT60 FPV RC Dominator
US$7.99 US$9.59
0
Recommendations
Comments (0)
troh 23/08/2018
Haven't yet breark even one.
5 PCS Banggood 220mm Battery Tie Down Strap for RC Drone FPV Racing
US$5.99 US$7.99
0
Recommendations
Comments (0)
troh 23/08/2018
Cost effective 4in1 ESC. Have also current sensor. There is not engouh capacitance on the board, so external capacitor is required. I have 47uF at battery terminal and another 47uF at camera voltage. Good so far.
30.5x30.5mm Racerstar REV35 35A BLheli_S 3-6S 4In1 Brushless ESC Built-in Current Sensor Support DShot600 for RC Drone FPV Racing
US$35.99 US$37.99
0
Recommendations
Comments (0)
troh 23/08/2018
I have used these props with Emax RS2205S motors. They feel like not grippy, but haevy at the same time. Price and durability is good, though.
10 Pairs Racerstar Fish Bone 5041 3 Blade Racing Propeller for Racing
US$6.76 US$14.10
0
Recommendations
Comments (0)
troh 15/06/2018
Perfect for whooping. can charge 6 batteries in separated channels. Each channel you may select LiPo or LiHV and set charge current to 0.6 or 0.2A. how ever, if all channels push 0.6A, it wil get warm.
6 In 1 3.7V 1S Lipo LiHv Battery Charger Board For Inductrix 3.7V KINGKONG Tiny 6 Eachine QX65 E010 E011 E013
US$16.99 US$20.99
0
Recommendations
Comments (0)
troh 15/06/2018
Betaflight compatible FC with integrated OSD. -I was able to bind it only at D8 mode. You need to setup D8 at Betaflight as described in instructions. -When idling at strat line before armin, it may get hot. When hot, controls may not work properly. This might be due to method how VBat is regulated for RX of processor. I haven't found the real cause of symptom. In normal usage this is not an issue - it is rather an issue only when you idle too long before flight.
Eachine Beecore V2.0 Frsky D16 Brushed F3 OSD Flight Controller for Inductrix Tiny Whoop E010 E010S
US$32.39
0
Recommendations
Comments (0)
troh 15/06/2018
This is nice looking and handy set. The box have magnets to keep bits in order. Quality seems to be good. Good for drone repairs.
XIAOMI Mijia 24 in 1 Multi-purpose Precision Screwdriver Set Aluminium S2 Steel Repair Tools
US$32.99 US$42.99
0
Recommendations
Comments (0)
troh 11/06/2018
These are simply the best 2540 propellers I have tested so far. Thrust and tracktion are are good. Durability could be better.
4 Pairs Gemfan Flash 2540 2.5x4 2.5 Inch 3-Blade Propeller with 1.5mm Mounting Hole for RC Drone FPV Racing
US$5.99 US$9.99
0
Recommendations
Comments (0)
troh 04/06/2018
Nice small ESC that has high current ratings. how ever, ripping with Sunnysky 1106 6500kv motors might be more of a task than this ESC can handle. This is not an ESC for superlight 5" build even though current rating may look like suitable. For a tight builds, outer dimensions are good. Board doesn't extend to forward nor backward too much out from 20x20 pattern.
20x20mm BS-28A 4in1 2-4S BLHELI_S ESC Support PWM Multishot Oneshot DSHOT 4.1g for RC FPV Racing Drone
US$36.99 US$44.99
0
Recommendations
Comments (1)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe