All Messages

Q: what filaments should I use

Asked by BG851454317 on 2022-03-29 03:27:20

paulomartins Isto é uma estação de cura e lavagem para modelos feitos em impressoras de resina, não é uma impressora 3D.

2022-03-29 04:21:14 Helpful (0)
Submit
Answers (1)

Q: What is the polarity of these magnets?

Asked by BG938353949 on 2020-11-19 06:12:56

paulomartins My friend, ANY magnet in the word has two polarities. If you break one in half, you will get two smaller magnets, both with north and south polarities.

2020-11-19 08:46:32 Helpful (0)
Submit
Answers (2)

paulomartins Well, you must search and learn. this is a board of relays controlled by the ESP8266 board (that small detachable board on the bottom left corner). You MUST know how to program and control that board. After that you can control the relays, Search the internet for "ESP8266 for beginners", it will be very hard to find easy instructions, like in a kit.

2020-08-13 05:24:01 Helpful (0)
Submit
Answers (2)

paulomartins This is an ESP8266 board. You must learn how to work with it. There's tons of info out there, but you must be a tech nerd, though. After that is easy.

2020-07-05 04:26:04 Helpful (0)
Submit
Answers (1)

Q: How to connect this relay to internet

Asked by BG874810352 on 2020-05-29 04:27:02

paulomartins it has an ESP8266, so... You must learn how to connect the ESP to the internet and interact with its output pins, then move on to this.

2020-05-29 05:04:22 Helpful (0)
Submit
Answers (2)

Q: output regulation voltage is AC or DC ???

Asked by Tomáš Zadražil on 2020-04-19 01:27:43

paulomartins AC only, no DC involved here.

2020-04-20 03:47:00 Helpful (1)
Submit
Answers (5)

paulomartins it doesnt work. needs to be connected to charger even with full charged batteries. if we disconnect from wall charger it stops charging the phone

2020-03-10 04:26:35 Helpful (0)
Submit
Answers (9)
paulomartins 02/01/2020
0
Recommendations
Comments (0)