prateekgupta1972
BG183717420 Alsoforgot to mention, as this is low power module kindly keep the laser speed between 5 to 7 mm/sec(300 to 420 mm/min). Also Creality workshop is working but you have to adjust the image as it does not have offset setting. Have no success with photo printing mainly because the module works on 5V and when you convert 24 v to 5V, it has no laser output below M106 S230
BG183717420 you can expect 4 to 5 w optical output
2021-04-15 01:51:05 Helpful (2)Q: What do i need to run this? is Ramps board enough or do i need special board ?
Asked by BG455510415 on 2020-09-11 06:22:14
BG183717420 Youneed to supply5 v supply. If you have 12 or 24 v supply you need to buy dc to dc step down converter separately
2021-04-12 06:13:54 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
