All Messages

LeROYtheLAMA It is not good quality! If you care about your project, want soldering to go smooth and/or have soldered with quality solder before, you will not be satisfied with this product. If you have a $200-500 quad (or any project with value), why ruin it with bad solder?

2018-09-02 07:39:08 Helpful (3)
Answers (4)

Q: does it maintain constant output current? or just the tension?

Asked by Peppequarta on 2020-03-13 05:54:49

athensgr1 customer support

2022-03-11 07:47:46 Helpful (0)
Answers (3)

BG424857182 I bought this product for PCB soldering yeah

2022-03-01 03:47:11 Helpful (0)
Answers (2)

Q: how ampere supports this pug? tenks

Asked by quapeppe on 2018-06-10 08:38:52

noor it's support 3 to 4 Amp maximum

2021-04-10 01:30:52 Helpful (0)
Answers (2)

Peppequarta Yes, is required heat sink , current is 1.3A.

2020-04-02 04:50:06 Helpful (0)
Answers (1)

Q: Does it fit a hero 6?

Asked by zhuyiping1688 on 2019-10-11 08:14:06

Peppequarta yes

2020-03-29 02:34:11 Helpful (0)
Answers (1)

Peppequarta Ciao,i due potenziometri che si vedono blu servono uno per regolare la corrente in uscita e l'altro per regolare la tensione in uscita ? sapresti darmi qualche informazione in più Grazie.

Pallina 28/02/2020
Comments (2)

Q: Hi, With this product you can command a 220V lamp?

Asked by Peppequarta on 2019-10-23 06:11:53

wictro NO! The relay is rated 230V, but as the circuit board does not advertise to handle 230V, the leads might be to close to each other an arching could occur. Also the power to the board is made for 12V, so powering it with it 230V might fry the whole board. Get a 230V version:

2019-10-25 09:35:21 Helpful (0)
Answers (1)