Realacc F3 V1.0 Betaflight Brushed Flight Control Board Integrated OSD with Buzzer STM32 F303 MPU600
A part of the review has been auto-translated.
It would take me an hour to tell you all the good things about this board. I was inspired by the Eachine QX95 and wanted to build my own version of it. You can watch that on YouTube, https://youtu.be/OzMbVii0_cU. There are F3 EVO boards with newer chipsets but they don't have the On Screen Display. Personally, I don't think this FCB needs better stabilization. I like getting feedback from the aircraft especially when I can't see or hear it.
works well with fs-a8s receiver. connect TX to RC_IN, then use uart3 as serial RX
Bem comprei Realacc e recebi Eachine, mesma placa, será mesma empresa? Desconheço, mas não importa, sou fã das duas mesmo. Extremamente pequena e leve, melhor não podia ser. Betaflight reconheceu de primeira, ainda não acabei de receber e montar o mini drone Q95, mas agora será pura diversão.
It has everything you need on your QX! Suitable with i-Bus and FS-A8S, 100% working. OSD works pretty well on a TX01 with OSD MOD. It is possible and suggested to solder the connectors for the motors. so you just need to plug and play!
Unfortunately, the boards I received have a different layout (although similar features and size) which makes accessing the USB port a tedious undertaking with the frames I intended to use. They also took over a month to ship, so I won't be bothering further.
Please find full review here - http://intofpv.com/t-realacc-v1-brushed-micro-fc
The received board has distribution to the right but otherwise works correctly, I would have preferred with the USB on the side to have the power cable centered. It does not enter the body of a normal Tiny, for that a plate type BeeCore is needed although some adaptation can be done XD
Needed to upgrade firmware to work with flysky ibus protocol. Make sure to get the right firmware OMNIBUS and everything works perfectly
i used this fc in my e58 with a 700tvl cam on a 350mw vtx and an x8b receiver i can get about 1.3km with this set up
El tablero recibido tiene muy buena pinta