Very high-quality assembly! But there are problems: - Missing low-pass filter for the 6-meter band. - Power drop with increasing frequency from 100 W on the 160, 80, 40 meter bands to 49 W on the 10 meter band. - Very unpleasant smell of the glue used in the assembly of the case, I hope it will dissipate over time. - RX, TX outputs on the rear panel, used for connecting transverters, are not connected to anything. - The use of lead-free high-temperature solder makes soldering during repair and improvement of the boards difficult. - The power supply wires used in the assembly with silicone insulation have a very small cross-section for a large diameter of insulation, which leads to wire breakage during the disassembly of the transceiver.

Очень качественная сборка! Но есть проблемы: - Отсутствует ФНЧ 6 метрового диапазона. - Спад мощности с повышением частоты с 100 Вт на диапазонах 160, 80, 40 метров до 49 Вт на 10 метровом диапазоне. - Очень неприятный запах используемого при сборке корпуса клея, надеюсь, что он выветрится со временем. - Выходы RX, TX на задней панели, используемые для подключения трансвертеров, никуда не подключены. - Использование безсвинцового высокотемпературного припоя затрудняет пайку при ремонте и усовершенствовании плат. - Использованные в монтаже проводов питания в силиконовой изоляции имеют очень малое сечение при большом диаметре изоляции, что приводит у переламыванию проводов при разборке трансивера.

Very high-quality assembly! But there are problems: - Missing low-pass filter for the 6-meter band. - Power drop with increasing frequency from 100 W on the 160, 80, 40 meter bands to 49 W on the 10 meter band. - Very unpleasant smell of the glue used in the assembly of the case, I hope it will dissipate over time. - RX, TX outputs on the rear panel, used for connecting transverters, are not connected to anything. - The use of lead-free high-temperature solder makes soldering during repair and improvement of the boards difficult. - The power supply wires used in the assembly with silicone insulation have a very small cross-section for a large diameter of insulation, which leads to wire breakage during the disassembly of the transceiver.