LDARC / Kingkong 20x20mm Flytower 12A BLheli_S ESC & Omnibus F4 FC AIO OSD & 48CH 0/25/100/200mW VTX
A part of the review has been auto-translated.
The flytower comes with screws, nuts, spacers and cables. Everything is well wrapped and in a nice little box. The build is easy and the cables are labeled, so it is easy to identify the connections. I use this stack with an 80 mm frame and 4 T-motor F10 1104 7500KV 2-3S Brushless Motors on 2s. Flies extremely well. Every part of the flytower can be bought seperate.Very practical, if you need a spare part.
great stack with all the small power you need. 20x20 for great in my 3" build. easy to put together. easy USB and button access from the sides.
i like it and works perfectly
small but simple
Amazed with the performance of this little guy. 12A ESCs are a bit to small for powerful 1106 motors. Replacing it for the 20A version. VTX is fantastic, able to output 600mW, that's CRAZY! Flight controller has anything you need and the gyro runs at 8 Mhz. Comes with all the accesories you would need (screws, spacers, leads...) 100% recommend.
Extremely easy to install. Flies extremely well. Very light weight. I have mine installed on a Flex RC Ascent 4 inch frame with dys 1306 3100 kv motors. Gemfan 4045 two-bladed props. 3s 1000 mah 30C batteries. Whole quad weighs 214 grams with battery installed. Am getting over 12 minutes of flight time if I take it easy on the throttle. Highly recommend.
Очень была привлекательная штука. Купил, чтобы зимой, да в закрытых пространствах... Не так все радужно. Регули не заработали сразу. Выписал платку регулей еще. Там другие начали отключаться. Плата видеопередатчика коротила с самого начала, ну ладно, сделал напрямую, вроде близко-низко, но тут самая главная проблема. 3 контакта приемника, всего 3 "+", "-", sbus! Так вот. Один r-xsr и два XM+, просто в секунду сгорели. Далее боюсь что-нибудь подключать, хотя, по инерции, еще этого не зная, заказал у продавца еще одну пирамидку. Сам не новичок, но обидно.
Good stack! easy to build and work on, but it's a little on the tall side so it's hard to find a frame to fit it into! I had to do a little bit of modifications to make it fit!
good service but received a dead flight controller board no power to board at all betaflight does not recognize the board
will use on my 2.5 build