This antenna is performing much better than expected. As given by the seller, the SWR is low from 160m to 10m. I have not used it on every possible HF-band but it performs very nice from 30m to 15m. I have installed it 2 meter above ground, with two copper rods 1,5 meter into good ground. With this configuration it clearly perform best from NVIS to approx 800 km. Will later try it higer above ground. It dissipate some of the transmitted power via the end resistor into the ground, but I will say it is reasonable effective, all considered. The seller says it can do 1000 W, I would not go so high though, considering the rather tiny thickness of the wire. 100 W is what I have used, with good results. Recommended! LB7ZG

This antenna is performing much better than expected. As given by the seller, the SWR is low from 160m to 10m. I have not used it on every possible HF-band but it performs very nice from 30m to 15m. I have installed it 2 meter above ground, with two copper rods 1,5 meter into good ground. With this configuration it clearly perform best from NVIS to approx 800 km. Will later try it higer above ground. It dissipate some of the transmitted power via the end resistor into the ground, but I will say it is reasonable effective, all considered. The seller says it can do 1000 W, I would not go so high though, considering the rather tiny thickness of the wire. 100 W is what I have used, with good results. Recommended! LB7ZG

This antenna is performing much better than expected. As given by the seller, the SWR is low from 160m to 10m. I have not used it on every possible HF-band but it performs very nice from 30m to 15m. I have installed it 2 meter above ground, with two copper rods 1,5 meter into good ground. With this configuration it clearly perform best from NVIS to approx 800 km. Will later try it higer above ground. It dissipate some of the transmitted power via the end resistor into the ground, but I will say it is reasonable effective, all considered. The seller says it can do 1000 W, I would not go so high though, considering the rather tiny thickness of the wire. 100 W is what I have used, with good results. Recommended! LB7ZG

completely fine!

helt ok!

completely fine!