G8 Dimmable LED Bulb 3W SMD 3014 80 Pure White/Warm White Silicone Light Lamp AC 110V/220V
A part of the review has been auto-translated.
Although sold and packaged as G8 bulbs (8mm pin spacing), what was actually inside were G4 bulbs (4mm). A little modification with needle nose pliers and they fit OK. Other than the base error, they're great bulbs. At least as bright as the halogen bulbs I'm replacing, but a lot cooler. . Also, a little bigger than old halogen bulbs. I can't get the safety glass cover back on a few of the fixtures, but don't figure I'll need that protection with these cooler bulbs.
super OK
Very satisfied
LED all the way
la lampada si presenta bene sia nell'imballo che come oggetto
I note that several comments about the wrong size for G8 socket. When I received bulb though I had the same problem. However, on inspection of the lamp found there were 2 sets of contacts. One for my US G8 bulbs and another for your G8 bulbs. They only worked when I connect the hot to one of the smaller pin holes. Once I got the hang of it all worked fine. My only question if is the plastic cover is to come off?
No lo he probado aún pero, en apariencia, se ajusta a los especificado.
the blub PINS are BIT SHORT (length) to replace halogen blub. These pins don't fit in the blub socket . the blub is lose in the socket .
The bulbs are not the correct size. It seems that they are G4 bulbs (~1/8 inch space between terminals). I ordered G8 bulbs (~5/16 inch space between terminals). I have included a photo showing the differences. The ruler shown is NOT metric (sorry, for whatever reason my county hasn\\\'t adopted the metric system) and each line represents 1/32 of an inch. The bulb I\\\'m holding in the photo is the LED and the other one is the existing halogen bulb to be replaced.
These bulbs were advertised as being compatible with 120v. G8 sockets but the pins are the wrong size. The pins are too close together to fit into G8 sockets. I want the seller to take them back and refund my purchase price.