Freewing 1026mm Wingspan EPO Delta Wing FPV Flywing RC Airplane PNP
A part of the review has been auto-translated.
Received this wing today and build completed in about 3 hours (I know it’s too long for a PNF plane). Good things- 1) Components used are of good quality. Motor is quite powerful Servos are MG and very smooth. ESC is probably HobbyWing 30A. Servo linkages are also precise. Some build issues to take note of - 1) Manual fully in Chinese can’t understand where is the CG also. 2) The CF rod installation design is the worst I have seen so far. The bar doesn’t provide enough support. not sure how many crashes it can survive. 3) FPV Camera position doesn’t seem so good. it would probably obstruct the camera. however I haven’t tried it yet but not a big problem. can cut the foam if required. 4) Canopy looks very loosely attached due to weak magnets. will have to secure using Rubber band or a tape before flight. else change the magnets to a powerful ones. 5) Propellers are of cheap quality. Buy a good quality 6x4 props. 6) Servos were installed like a big joke. They were simply fixed to the plane using a thin double sided tape which came off in just one tug. Must takeout that tape and use Uhu Por or similar glue to fix the servos. Overall the wing profile looks exactly like Z84 but just bigger than it. So I assume it should give good flight time. Will fly the plane and test it in a day or two.
excelente produto comprei duas veio numa caixa e não foi taxado muito bom