Ship to 
United Kingdom , USD
United Kingdom , USD
United Kingdom , USD
New customer? Start here.
My Account My Orders My Wishlist My Coupons My Points My Referrals BGpay
17% OFF
Eachine QX65 with 5.8G 48CH 700TVL Camera F3 Built-in OSD 65mm Micro FPV RC Drone Quadcopter
US$74.99
US$89.99
View It
123 Change the receiver's protocol from SPEKTRUM2048 to SPEKTRUM1024
Reply 04/02/2018
Tatjana Leto You have to setup your transmitter from 1000-2000 otherwise it will nont arm.
Reply 07/02/2018
highks Maybe there is a throttle-cut programmed for one of the switches? You\'d need to disable the throttle cut to start the motors. You can look at the programming of all the switches by connecting the quad to betaflight.
Reply 08/02/2018
highks You need to flip the arm switch in order to get the motors spinning. Don't know where that switch is on this quad or on your transmitter, but you can look it up in betaflight.
Reply 12/02/2018
borvanbeers Did you arm the quad? Google on how to do this if you haven't already armed it.
Reply 15/02/2018
Jesse Have you configured it in Betaflight? You may need to connect it to your computer and change a few settings?
Reply 18/02/2018
Klaus_R same problem here; learning a lot about deviation and betaflight - but obviously not enough to program an arming switch on my TBSG :/
Reply 19/02/2018
redfactorman there is a youtube video that covers connecting a DSM2 in betaflight.
Reply 22/02/2018
AdrianD90 Have you changed the arming sequence in betaflight to a switch and checked for low throttlejQuery19106909420793233754_1519818236483
Reply 28/02/2018
Fernando I had trouble arming until I lowered the throttle trim
Reply 16/03/2018| Our Company | Contact Us | Payment & Shipping | Partnership Programs |
|---|---|---|---|
