Customer Reviews

4.87 out of 5
See all 38 reviews
Write a Review
  • All Reviews (38)
  • Image (4)
  • Video (0)
  • All Star
    • All Star(38)
    • 5 Star(34)
    • 4 Star(3)
    • 3 Star(1)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
|
Show Original

A part of the review has been auto-translated.

  • 11/04/2021

    Intelligent module for detecting the status of the inserted filament. The sensor automatically stops the 3D printer when the filament runs out, to prevent it from continuing to print until the file is finished leaving an incomplete print that will require restoration of the print file. Sales Unit: 1 x module - Material: plastic - Applicable filament diameter: 1.75 mm Used with Lerdge card: When filament is present, the green light in the module remains on. When the filament has run out the green light goes out, then the motherboard performs the pause command operation, after replacing the filament, it can continue printing. Wiring: Connect the module to the M sensor port on the motherboard. Used with other motherboards: The filament detection module uses the layer transition detection method. When there is material/filament inserted, the detection port level signal should be high level. When there is no material, the port level signal becomes low. If a high-to-low transition is determined, that is, the system detects a certain high-to-low transition, the material is considered exhausted, and the tab executes a print-pause command. After you replace the material/filament, the printer continues to print.

    Comments
    Show Original
  • 04/09/2021

    HENÜZ DENEMEDİM FAKAT GAYET SAĞLAM VE PROBLEMSİZ GELDİ.

    Comments
    Show Original
  • 16/05/2021

    arrived quickly and well packed, no damage to part or package.

    Comments
    Show Original
  • 08/03/2021

    great little mechanism

    Comments
    Show Original
  • 19/08/2021

    Came as described & works perfectly, only down side is as I positioned it on top of the printer the cable wasn't long enough, But would be perfect for side mounting .

    Comments
    Show Original
  • 20/04/2021

    Great little item, with a full length cable that connects from the motherboard and reaches to where the extruder is placed, for clear running direct from the sensor to the extruder, no doubt offering peace of mind when it comes to properly monitoring the filament.

    Comments
    Show Original
  • 28/06/2021

    Product not checked yet as I'm waiting for the main board to be delivered (Bought from Banggod)

    Comments
    Show Original
  • 19/09/2021

    nice

    Comments
    Show Original
  • 07/09/2021

    Unit arrived quick and works well in ender 3 with SKR mini e3

    Comments
    Show Original
  • 31/08/2021

    Good quality product

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$5.99
    • US$20.99
    • US$6.99
    • US$5.99
    • US$8.99
    • US$2.99
    • US$8.99
    • US$27.99
    • US$12.99
    • US$10.99
    • US$10.99
    • US$10.99
    • US$19.99
    • US$39.99
    • US$11.59
    • US$7.99
    • US$42.99
    • US$99.99