A part of the review has been auto-translated.
received as described thanks Banggood is better than amazon
Although Blheli_S 40A, F4 FC is built-in and this size Not more than 6mm thick It's a 40A burst 45A, so we can only use a powerless motor Since the Yuru motors that we started are still doing well I'm going to build a training aircraft that will fly the narrow space with it.(^-^) I also bought a cheap and light frame (5 inches) Aiming for lighter aircraft (^-^) For now, here's an FC internal ESC and a DVR internal VTX It's about 100g in camera and frame I think I can do some light quads (^-^) If T-motor's Raptor delivers it, the plane to replace the Yule Motor will exceed 100g in frame alone It has LEDs, separate DVR GPS, and 60 A ESC on the waste (?) Still, the 2205/4300kv Yuru motors fly pretty well It's a motor that feels pretty slow now Isn't that good for flying in an unfamiliar environment? I think (^-^) I will give the best rating in the hope of doing a good job(^-^)
This is my second purchase (^-^) I think it's basically a good product 4x40A 4in1 plus F4 but 5in1 board with BEC.OSD with FC Blheli_s, F4, and the old-fashioned combination No problem (^-^) The last part was too low, and the OSD circuit was faulty when the propeller was hooked on the lawn Blackout now I input the VTX from the camera without using the OSD circuit and I use it now I don't know if it's bad luck or the circuit is weak originally, but I don't have to worry if there's no OSD If you buy it when it's cheap, you can end it with this (^-^) I repurchased it to use it for a new aircraft because it was cheap again this time (^-^)
Goods as described for fast shipping
good price, easy to weld, lightweight, simplifies the drone assembly and supports 6s
nice layout and very capable 40a 6s flight controller
the best AIO flight controller esc i ever used i fly it with 6s 1700kv xing mottor and 6/5 inch prop fly really smoth no need filters
All in one, spectacular
This is the only all in one board I found at time I bought it. You can use a frame with a tight room for electronics. Cons: No enough solder pads. I will use same pad for cam and vtx. Already bound and flown LOS. Failed flash to 4.2.9 so I reflashed to 4.2.3 . Smooth.
goods bought more than once quickly and efficiently, only connect and see if everything is ok