2 Axis Milling Compound Working Table Cross Sliding Bench Drill Vises Fixture DIY
A part of the review has been auto-translated.
Доставка быстрая упаковка плохая (как будто играли посылкой в футбол )из-за этого качество товара не удолетворительное. Теперь требуется ремонт ручки -штурвала. Я купился на цену но ошибся.Я опечален.
Position screws are stainless steel and Position nuts are brass made, Slides clearance can be tuned by thre set screws with lock nuts each axis, the black cap on the picture goes on the rear nuts of the short axe drive screw. It will be easily motorised for DIY esperts. My suggest for a long life and easier work is to spray the drive screws with lithium grease once in a while. I add diy card ruler on one wheel, see pics.
item received the packing was not the best. The item itself is not the best and not so precise but for the price is ok.
👍🏼👍🏼
The great product
And the tool I was waiting for.
Perfect
Для тех, кто дома занимается творчеством, самоделками, это приспособление необходимо для сверления и фрезерования. Особенно для изготовления печатных плат при изготовлении электронных устройств.
I liked this cross table but I think it didn't have what is very necessary when turning the cranks does not know how much shifted mm of the lie one and the other direction it would be good to put it on the wheel how much it lay moves not put there i Gelite tape with bad data
Chegou hoje, mas não gostei muito foi das folgas existentes nos dois eixos. Pensei que teria menos folga, mas por 24€ não estava à espera de muito melhor. Se fossem 44.45€ não a queria por causa das folgas.