The GPS-VFO has arrived today. I unpacked it and had to find out that it is very poorly processed (SMA connector nuts loose, front panel stands over the housing, is too large, screw holes not countersunk. And the frequency accuracy is poor at 10 MHz 5 Hz too low and with increasing frequency it gets worse.)

Der GPS-VFO ist heute angekommen habe in ausgepackt und mußte feststellen das er sehr schlecht Verarbeitet ist ( SMA Anschlüsse Muttern Lose, Frontplatte steht übers Gehäuse ist zu groß, Schrauben Löscher nicht gesenkt. Und die Frequenz Genauigkeit ist schlecht bei 10 MHz 5 Hz zu tief und mit steigern Frequenz wir es schlimmer. )

The GPS-VFO has arrived today. I unpacked it and had to find out that it is very poorly processed (SMA connector nuts loose, front panel stands over the housing, is too large, screw holes not countersunk. And the frequency accuracy is poor at 10 MHz 5 Hz too low and with increasing frequency it gets worse.)

Just to test my product it was used in a temporary build direct conversion receiver setup__It was an experience !__Consider to build a full version -_later ;)__OZ6BS,x-DJ0DZ,x-OX3BS_73 Cuagn on CW

Just to test my product it was used in a temporary build direct conversion receiver setup It was an experience ! Consider to build a full version - 'later' ;) OZ6BS, x-DJ0DZ, x-OX3BS 73 Cuagn on CW

Just to test my product it was used in a temporary build direct conversion receiver setup__It was an experience !__Consider to build a full version -_later ;)__OZ6BS,x-DJ0DZ,x-OX3BS_73 Cuagn on CW