Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Nice finish 3D printing nozzle diameter 0.4mm. Very sharp tip, there is hardly any surface around the hole to squeeze the plastic flat. Not tested in printing jobs yet. I wanted to put this on my anet A8 but I fear due to the small body of the nozzle it will not be very temperature stable when printing at higher speeds.

Para repuesto impresora Anet A8, buen aspecto

Para repuesto impresora Anet A8, buen aspecto

Para repuesto impresora Anet A8, buen aspecto

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

can’t go wrong with some spares will use them when i get around for my carbon fiber filament

llego perfecto para mk8 tevo tarantula

llego perfecto para mk8 tevo tarantula

llego perfecto para mk8 tevo tarantula

Object as described.The object looks well done.

Object as described.The object looks well done.

Object as described.The object looks well done.

I am satisfied

I am satisfied

I am satisfied

Muy buen producto, Gracias BANGGOOD.

Muy buen producto, Gracias BANGGOOD.

Muy buen producto, Gracias BANGGOOD.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

The surface at the bottom of the nozzle is very smal so your filament has less chance to stick to the bottom side .always check the diameter of the nozzle hole to make sure your settings are right.

14 days, not bad. However, while both nozzles I ordered are 0.4 with the same thread length, they are different. One is like pictured (slender tip), the other has a wide tip (like usually mk10 nozzles have). Nonetheless, not bad

14 days, not bad. However, while both nozzles I ordered are 0.4 with the same thread length, they are different. One is like pictured (slender tip), the other has a wide tip (like usually mk10 nozzles have). Nonetheless, not bad

14 days, not bad. However, while both nozzles I ordered are 0.4 with the same thread length, they are different. One is like pictured (slender tip), the other has a wide tip (like usually mk10 nozzles have). Nonetheless, not bad

estupendo producto para mi impresora 3d, no tengo que andar limpiando las boquillas, por el precio y calidad no merece la pena, se pone una nueva y a seguir trabajando

estupendo producto para mi impresora 3d, no tengo que andar limpiando las boquillas, por el precio y calidad no merece la pena, se pone una nueva y a seguir trabajando

estupendo producto para mi impresora 3d, no tengo que andar limpiando las boquillas, por el precio y calidad no merece la pena, se pone una nueva y a seguir trabajando